Use of the power tool for operations different from those intended could result in a hazardous situation.Ģ3. Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.Ģ2. Many accidents are caused by poorly maintained power tools. If damaged, have the power tool repaired before use. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool's operation. Power tools are dangerous in the hands of untrained users.Ģ0. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Such preventive safety measures reduce the risk of starting the power tool accidentally.ġ9. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.ġ8. Do not use the power tool if the switch does not turn it on and off. The correct power tool will do the job better and safer at the rate for which it was designed.ġ7. Use the correct power tool for your application. Once again, there are No Refunds on this Item.16. If this Full Wave Control Panel is installed into a Stand with a Half Wave Magnetic Base, the Control Panel will be Destroyed. If the reading is between 37 and 45 Ohms, this part won't work, you will need the Half Wave Control Panel. The Resistance of a Proper Operating Full Wave Magnetic Base Should be Between 97-119 Ohms. Measure the Resistance Across the 2 Lead Wires with the Base Disconnected from from the Stand. To Determine If Your Magnetic Base is Full Wave or Half Wave, Disconnect the 2 Magnetic Lead Wires (A and B) going from the Magnetic Base to the Control Panel. Before Purchasing, you must make sure you are ordering the correct part. Part # 23-35-0312 Replaces Part # 23-35-0311įits the following Tools: 23-35-0300 Mag Stand Control Panel 4201 (SER 498-11741) Medium Base Electromag Drill Press StandĤ201 (SER 498-13900) Medium Base Electromag Drill Press StandĤ201 (SER 498A) Medium Base Electromag Drill Press Stand 4202 Electromagnetic Drill Press StandĤ202 (SER 598-1001) Electromagnetic Drill Press StandĤ202 (SER 598-10475) Electromagnetic Drill Press StandĤ202 (SER 598A) Electromagnetic Drill Press StandĤ202 (SER 598B) Electromagnetic Drill Press StandĤ202 (SER 598C) Electromagnetic Drill Press Stand 4203 (SER 838A) Electromagnetic Drill Press StandĤ203 (SER 838B) Drill Press 4221 (SER 499-7780) Large Base Electromag Drill Press StandĤ221 (SER 499-8750) Large Base Electromag Drill Press StandĤ221 (SER 499A) Large Base Electromag Drill Press Stand 4231 (SER 500-13210) Adjustable Base Electromag Drill Press StandĤ231 (SER 500-15800) Adjustable Base Electromag Drill Press StandĤ231 (SER 500A) Adjustable Base Electromag Drill Press Stand Important: This is a Full Wave Magnetic Base Control Panel Kit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |